Jonathan1986
New member
Some Dummy questions: Why does the jack soldering pin holes have 8 holes instead of the usual 6? Is it a special type of jack? Also, does anyone have a drill template for it by any chance?
Micro Buffer
- Thread starter Jonathan1986
- Start date
Nostradoomus
Well-known member
That would make sense, as the usual suspects from Tayda for stereo jacks are enclosed.
I can't find them at a glance it's the serated washer with 2 pins looking thing. Probably since the buffer is only mounted via the jacks... Gives it a little more security and rigidity so not all the flex is on the jack solder pads.
Robert
Reverse Engineer
It's for a Cliff FCR14422, it grounds the enclosure since the jacks are plastic and make no electrical contact.
You only need one, not both, but they can cause the PCB to tilt slightly so the option is there for two.
You only need one, not both, but they can cause the PCB to tilt slightly so the option is there for two.
Similar threads
