Some Builds that went well over the last few months ....

[griff10672]

Valhalla Distortion ....



The Betty Boost



Derailer Overdrive



Magnetron Delay



Sanguine Distortion



Paragon





waddle box



Kazoo for the girlfriend ... one of my favorite fuzz's

 

[JetFixxxer]

Nice build.

Boostah.. must be a New Englander..

 

[griff10672]

Nice build.

Boostah.. must be a New Englander..

Sure nuff !!

 

[tcpoint]

Nice builds.

 

[JetFixxxer]

 

[griff10672]

P90 LP ?????

 

[JetFixxxer]

P90 LP ?????

Yes 50's Tribute (First Release). It's not that color any more.
First paint job (which I should have kept it this color) - Gibson minibuckers.

Now went to gold (Pickup Combo is kind of opposite of my BFG) - pickups are my winds.

 

[griff10672]

Yes 50's Tribute (First Release). It's not that color any more.
First paint job (which I should have kept it this color) - Gibson minibuckers.

Now went to gold (Pickup Combo is kind of opposite of my BFG) - pickups are my winds.

Sweet !

 

[binting]

Nice build! Where did you purchase the 25k reverse log pots for your vh4 build?

 

[griff10672]

Nice build! Where did you purchase the 25k reverse log pots for your vh4 build?

I couldn't find PCB Mount C25k pots ...... I bought solder lug ones from Smallbear I think it was .... and wired them in .

 

[binting]

I couldn't find PCB Mount C25k pots ...... I bought solder lug ones from Smallbear I think it was .... and wired them in .

Thanks man

 

[geekmacdaddy]

Damn! Gorgeous work, and finishes. Well done, Griff.

 

[evitative]

Thanks man

I'm looking into putting one of these together right now. Did you have any luck with Small Bear on the C25k pots? I could only find them with solder lugs on Mammoth.

 

[HamishR]

FWIW I have bought solder lug C25K Alphas with a solid shaft from Mouser. They may have board mount there as well.

 

[griff10672]

FWIW I have bought solder lug C25K Alphas with a solid shaft from Mouser. They may have board mount there as well.

I find looking for pots on Mouser very daunting ....... unless you have an exact part number .

 

[HamishR]

Haha! Yes it sure is. They have so much stuff... but I managed and now quote the same number that's on the bag each time I reorder. In fact I just had some delivered not 1/2 an hour ago, so for solid shaft C25K Alpha pot with solder lugs the Mouser code is: 313-1560F-25K. These have the 1/4" shaft so will be approx 6.8mm or so? I'd rather they were the standard 6mm but at least they are C25K!

 

[TheMoonTotem]

How did you do the decals? Thanns

 

[griff10672]

How did you do the decals? Thanns

Waterslide decal and epoxy