Taqueria Overdrive PCB - Available Now!

As I understand it, normally the drain and source (D and S) are interchangeable. So you really just need to make sure your gate (G) is lined up right, and you should be good. The gate is the one on the single connection side.

If you look close at the traces on the PCB and your adapter board, you should be able to see what's connected to what.

Double-check me, but I'm seeing them as highlighted below in which case, I think you've got it the right way.

1747848628702.png

1747848692975.png
 
thanks for your help, i tested the board without FS and it is working, great !
Now i am confused about the final connections between main PCB / breakout board and IN/OUT jacks.
This what i did, but now i don't know what to do with the Jacks IN & OUT wires....(i connected in gnd sw out from the main pcb to the same on teh breakout board) so i guess i'm wrong.


IMG_1164.jpeg
 
thanks for your help, i tested the board without FS and it is working, great !
Now i am confused about the final connections between main PCB / breakout board and IN/OUT jacks.
This what i did, but now i don't know what to do with the Jacks IN & OUT wires....(i connected in gnd sw out from the main pcb to the same on teh breakout board) so i guess i'm wrong.


View attachment 95874

Just go purple next to purple and orange next to orange on the daughterboard and you should be good
3PDT (1).png
 
Back
Top