What's on the workbench?
- Thread starter Robert
- Start date
What The ----!!!
Not Bad, my Korg Nutube for your NuDrive PCB cost more than that way back then!!!
NuDrive
This was my 2nd PedalPCB build 12 months ago. I chose the Burst finish as the base Circuit is similar to the Eternity Burst but this has the Nu Tube in it. It has a piece of Soft Adhesive Foam between the Nu Tube & PCB to stop it from being Microphonic. It also has same Foam on the Back Plate to...
forum.pedalpcb.com
giovanni
Well-known member
I was eyeballing that at some point. Any demos?Not Bad, my Korg Nutube for your NuDrive PCB cost more than that way back then!!!
NuDrive
This was my 2nd PedalPCB build 12 months ago. I chose the Burst finish as the base Circuit is similar to the Eternity Burst but this has the Nu Tube in it. It has a piece of Soft Adhesive Foam between the Nu Tube & PCB to stop it from being Microphonic. It also has same Foam on the Back Plate to...
Sorry, No Demo.
fig
Village Idiot
Introducing,
Burson Audio makes some pricey stuff!
Nice! I was looking at one of these discreet op amps just yesterday.
Burson Audio makes some pricey stuff!
fig
Village Idiot
The one I saw, a V6 I think, was $150 . Would definitely make a killer headphone amp, and yes...plugging one into a pedal would be on the short list of experiments
benny_profane
Well-known member
Oh man, is it API 2520 hype time?
Cool, The only thing that needs updating is a Havoc momentary footswitch
If it has to go in a 1590BB, adopt the version 2 layout
Harry Klippton
Well-known member
Good lord what is that
