keithwarburg
New member
This is my first pedal build, but not my first rodeo with soldering and electronics. I think I have it all right, but when I try to run the pedal, I get no output to the amp. I can hear a low clean signal, but the pots and switch do nothing but light up.
Looking again, it seems that I put a 3-way toggle on the PCB for the tone switch rather than a 2-way On-On. That's what I get for using mystery suppliers (it was sold as an On-On, but the switch itself says On-Off-One.
Would the switch be the issue here? I have a new 2-way On-On inbound, but I don't want to get my hopes up if that's not the issue. Thanks!
Looking again, it seems that I put a 3-way toggle on the PCB for the tone switch rather than a 2-way On-On. That's what I get for using mystery suppliers (it was sold as an On-On, but the switch itself says On-Off-One.
Would the switch be the issue here? I have a new 2-way On-On inbound, but I don't want to get my hopes up if that's not the issue. Thanks!