Electro Vibe - Replace trimmers with potentiometers

[Super Delta Blues]

Hello everyone,

I want to replace the Bias and Gain trimmers with potentiometers to be able to adjust them from the outside. The Bias trimmer is 250k and according to the PedalPCB documentation the Gain trimmer is 500R, but I can't find any potentiometer of that value.

Any ideas? Some help?

Thank you!!!

 

[Betty Wont]

500 OHM Linear Taper Potentiometer PCB Mount Round Shaft Dia: 6.35mm

ALPHA - Get It Fast - Same Day Shipping

www.taydaelectronics.com

500 OHM Linear Taper Potentiometer with Solder Lugs

ALPHA - Get It Fast - Same Day Shipping

www.taydaelectronics.com

 

[Super Delta Blues]

500 OHM Linear Taper Potentiometer PCB Mount Round Shaft Dia: 6.35mm

ALPHA - Get It Fast - Same Day Shipping

www.taydaelectronics.com

500 OHM Linear Taper Potentiometer with Solder Lugs

ALPHA - Get It Fast - Same Day Shipping

www.taydaelectronics.com

Thanks, I was confused with a 500k. One is called 500K OHM OHMS and the other just 500 OHM OHMS

 

[Betty Wont]

Thanks, I was confused with a 500k. One is called 500K OHM OHMS and the other just 500 OHM OHMS

500 vs 500,000 ohms

 

[Super Delta Blues]

500 vs 500,000 ohms

All Right!!! Thanks

 

[andare]

All Right!!! Thanks

Btw Values below 1k are sometimes listed as xxxR. Typically that's for resistors below 1k ohms, not for pots. But I've never looked for pots below 1k.
So 500 ohms might be listed as 500R

Disregard if you knew it already

 

[Feral Feline]

Also, running a 1kΩ resistor across a 1kΩ pot's legs 1 and 3 would give you a 500Ω pot.

 

[Drayve85]

Just make sure you need a 500R pot, and not a 500K pot. Two VERY different things!lol