xefned Well-known member Jul 30, 2023 #1 I'm using a VFE bypass board (by Madbean) with Madbean's Pepper Spray (Harmonic Perc.) Audio switching works perfectly, but I can't figure out how to wire the LED. If I can't make it work, I'll just skip the LED, but it would be nice to solve this.
I'm using a VFE bypass board (by Madbean) with Madbean's Pepper Spray (Harmonic Perc.) Audio switching works perfectly, but I can't figure out how to wire the LED. If I can't make it work, I'll just skip the LED, but it would be nice to solve this.
xefned Well-known member Jul 30, 2023 #3 Knowing all this, I still can't find a place to tap voltage for the LED that goes to 0v when the effect is bypassed. Any ideas? I'm a bit stumped. Upvote 0 Downvote
Knowing all this, I still can't find a place to tap voltage for the LED that goes to 0v when the effect is bypassed. Any ideas? I'm a bit stumped.
xefned Well-known member Jul 30, 2023 #4 OK, future travelers, this works. Last edited: Aug 8, 2023 Upvote 0 Downvote
xefned Well-known member Jul 30, 2023 #5 If I had to do it again, I'd leave off the trimpot and wire the LED straight to the trimpot pads with a dangling CLR. Upvote 0 Downvote
If I had to do it again, I'd leave off the trimpot and wire the LED straight to the trimpot pads with a dangling CLR.
