Kliche mini- very low effect output

[peartplus]

Hi all,
I'm sure I'm missing something completely obvious, but I'm getting nearly no effect volume from my Kliche mini. Only when all knobs are maxed do I hear any distortion at all. Hoping one of you can see something I'm not!

Thanks!

 

[steviejr92]

are you using a dual gang pot for the gain knob?

 

[steviejr92]

cant remember off the top of my head but i believe its supposed to be a B100k dual gang pot for the gain knob

 

[Deperduci]

that's likely the issue looking at that corner the upper bank of holes are empty, I wish you luck getting the pot out, may haveto sacrifice the legs clipping them off then pulling the remaing metal out 1 at atime.

 

[Robert]

That's correct, this is what you need:

TAYDA 100K OHM Linear Dual Taper Potentiometer PCB Mount Round Shaft Dia: 6.35mm

Tayda Electronics - Get It Fast - Same Day Shipping

www.taydaelectronics.com

You can get them from StompBoxParts or Tayda Electronics.

 

[peartplus]

Knew it would be something obvious. Thanks, all. I appreciate it!