Muzzle Charge Pump - no solder pads for 1044

[KindCanuck]

I'm building a Muzzle Classic with the retrofit module, and plan on using a TC1044 charge pump. There aren't any jumper pads as indicated in the build docs, what pins should I jump on the socket?

Thanks!

 

[Robert]

It's not necessary, they're already jumpered on the newer revisions of the PCB.

You can verify by checking for continuity between pads 1 and 8 of the LT1054 footprint.

 

[Vanilla gorilla]

To be clear does that mean with the newer version a LT 1054 or a tc1044 can be used without issue?

 

[Robert]

Yes.

 

[Vanilla gorilla]

Awesome. Thanks
I’m having that high pitched squeal issue and have a couple on hand

 

[Vanilla gorilla]

That was it. TC1044s cleared it right up.

 

[ScottOldGuards]

It's not necessary, they're already jumpered on the newer revisions of the PCB.

You can verify by checking for continuity between pads 1 and 8 of the LT1054 footprint.

Hey Robert, is this the case for the range finder as well? I see the continuity track between 1 and 8,so I'm hoping I can use an lt1054 here? Thanks in advance

 

[Robert]

Yep. You can use either charge pump without issues.