What's on the workbench?
- Thread starter PedalPCB
- Start date
giovanni
Well-known member
Paradox916
Well-known member
So what did the natas end up being?
Robert
Reverse Engineer
I still have a lot of SMD capacitors to remove and measure, but basically it is: Boost > 3-Stage Cascaded JFET Amp sim > 5 Opamp stages of EQ/tone shaping > Output buffer
The boost is not exactly like a TC Pre but I would assume achieving a similar goal.
It's far from a Tubescreamer.
Sound like the Too Hard Basket just to go CHUG.I still have a lot of SMD capacitors to remove and measure, but basically it is: Boost > 3-Stage Cascaded JFET Amp sim > 5 Opamp stages of EQ/tone shaping > Output buffer
The boost is not exactly like a TC Pre but I would assume achieving a similar goal.
It's far from a Tubescreamer.
SMD, probably a 4 layer PCB, Did you say Jfet's & 5 Op Amps!???
Not for me!
Robert
Reverse Engineer
Five stages plus a buffer, so three TL072s. (and a TL071 for the boost)
Yeah, 4 layers would be way too hard to break by hand
You saw my mangled nail, I used 2 - 6'' Cresents!!!Five stages plus a buffer, so three TL072s. (and a TL071 for the boost)
Yeah, 4 layers would be way too hard to break by hand
How do you think I busted that other one with all the components on it!
A
Warning , Bit Graphic!
My Right Middle Finger now on my fretting hand from being squashed betwen 2 Pine posts 6 weeks ago, looks good now with some Supa Glue & Sanding!
Just gettin full sensitivity back in the tip & playing again!
Before shot after I removed the lifting nail:
My Right Middle Finger now on my fretting hand from being squashed betwen 2 Pine posts 6 weeks ago, looks good now with some Supa Glue & Sanding!
Just gettin full sensitivity back in the tip & playing again!
Before shot after I removed the lifting nail:
Last edited:
Feral Feline
Well-known member
YOUCH! Heal quickly.
And post regular updates!
And post regular updates!
Robert
Reverse Engineer
Feral Feline
Well-known member
Knotty Pine
Active member
Make sure you include the “mode” switch in the PCB please. Other traces do not include it. I have this pedal and I love using it as an OD on the “drum” setting - gives it a nice bump in volume and mids.
benny_profane
Well-known member
Did you put the goop on, then take it off?
Similar threads
