Thanks. The enclosure was actually pretty easy but only if you have the right tools. I used a harbor freight drill press. I then orders a drill press table vise that adjusts north, south, east and west in small increments by turning small handles. I used a side cutting mill bit in 2 or 3mm and just slowly turned the handle to cut the slots. As far as the white tips, I found them on eBay but I honestly can’t remember the wording I used to search for the them. I’ll see if I can go back and find them.
You’re right. Not sure why I put it under general questions. Probably an oversight. Didn’t realize that until you brought it up. Now, how do I move it?