benny_profane
Well-known member
Man, Rats are pretty cool. You should try one out. It’s kinda like a different tube screamer.
What's on the workbench?
- Thread starter PedalPCB
- Start date
fig
Village Idiot
It's a fuzzy muffy tone bending tube screaming etch-a-sketch.
I know this post was a week ago, but I can’t stop mumble singing “potato waaaave”.
Will it ever stop?
Bricksnbeatles
Member known well
nope. It’s forever
Bricksnbeatles
Member known well
Idk what it is, but it says HiWatt, so I want it
temol
Well-known member
Could you please take measurements of the enclosure and post it somewhere here?
Width, length, length of the flat and angled areas, approximate radius of the rear curved edge.
Width, length, length of the flat and angled areas, approximate radius of the rear curved edge.
Stickman393
Well-known member
I like your resistor organizational strategy, Bugg.
Robert
Reverse Engineer
If I'm being completely honest I haven't used those bins in years...
This is what I currently use. It's much quicker and easier to add a new value.
I've been meaning to repurpose those bins for components that don't fit into this system (jacks, LEDs, ICs, etc) for years, but as of right now it's just a waste of bench space and serves as a little shelf.
This is what I currently use. It's much quicker and easier to add a new value.
I've been meaning to repurpose those bins for components that don't fit into this system (jacks, LEDs, ICs, etc) for years, but as of right now it's just a waste of bench space and serves as a little shelf.
Robert
Reverse Engineer
It just looks good for instagram
You know it.
I mean come on. Haven't you seen the Wizard of Oz? Reality is just not as pretty.
Robert
Reverse Engineer
I'll see what I can do. Whatever you're up to over there I want in.
It's massive... just for comparison.
fig
Village Idiot
No cuts!Whatever you're up to over there I want in.
I want to see the Pedal wasted space!!!I'll see what I can do. Whatever you're up to over there I want in.
It's massive... just for comparison.
What, they couldn't label what the Knobs are doing??????????????????????
Now we're on Track!!!I'll see what I can do. Whatever you're up to over there I want in.
It's massive... just for comparison.
Maybe Mockup on the left is more practical !!!
Last edited:
Harry Klippton
Well-known member
I want to like this, but the knobs aren't labeled, therefore it is trash.
Last edited:
Similar threads
