Stickman393
Well-known member
It's a fuzz face.
What's on the workbench?
- Thread starter PedalPCB
- Start date
peccary
Well-known member
I love these little containers - were they from Amazon or are they something I can order online? I use something similar but they are all jammed up in to one little box and I'm spilling over.If I'm being completely honest I haven't used those bins in years...
This is what I currently use. It's much quicker and easier to add a new value.
I've been meaning to repurpose those bins for components that don't fit into this system (jacks, LEDs, ICs, etc) for years, but as of right now it's just a waste of bench space and serves as a little shelf.
View attachment 22039
benny_profane
Well-known member
Wait, so there's a frequency analyzer AND an LFO? Unreal.
I was originally thinking it was a micro amp, but the pot taper and the two 100u caps ended that. A tiny mu amp would be a good candidate for this, though.
I was originally thinking it was a micro amp, but the pot taper and the two 100u caps ended that. A tiny mu amp would be a good candidate for this, though.
Just a few parts short to be that:
RobinMallard
Member
The micro LFO is pretty sweet. A micro envelope follower would be pretty nifty so you could replace a pot with it for dynamic control of existing PCBs.
Grubb
Well-known member
I'm worried I'm going to get myself in trouble with the Mrs by saying "Make me fries" at a suboptimal moment
Bricksnbeatles
Member known well
I’m so ready for this!
benny_profane
Well-known member
How’re those going to fit on that little board?
What The ----!!!
Not Bad, my Korg Nutube for your NuDrive PCB cost more than that way back then!!!
Similar threads
