Delegate Compressor Boneyard Edition No Voltage at LED

[du37]

I was having some issues with the white LED that I had put in, and I soldered in a green one. Problem is, now it's not lighting up at all. I have continuity from the K side to all of the legs of the release pot, and continuity from the A side to the capacitor above it. When I measure the voltage at A and K, I get nothing, even when the optional LEDs are fully lit. Any ideas?

 

[Nostradoomus]

you need to post pictures

 

[du37]

Forgot to attach them this morning . It's the LED that goes right next to the photo resistor. The other small 3mm ones do light up and respond to playing.

 

[PJS]

Assuming you define continuity as under a few ohms resistance then you should only get continuity to all 3 release pot lugs with the pot all the way anticlockwise. Turn it as far clockwise as it will go and you should then get about 50k ohms between the LED K and the pot lug 1.

 

[du37]

When it's fully counterclockwise, there is continuity on all lugs. When it's fully clockwise there is continuity on the middle and left lugs only. I think my multimeter defines continuity as under 200 ohms but I am not sure.

 

[du37]

Solution: Trace from the A side got ripped out when I removed the original LED. I jumped a line from VCC and now it works.