Dan0h
Well-known member
well that was fast.
well that was fast.
No, this doesn't match that layout.Would that use a 5 knob enclosure from Tayda?
Not sure what the trimpot does, but you could use a six hole and wire a pot for the trimmer, may not be practical depending on functionWould that use a 5 knob enclosure from Tayda?
That’s almost definitely a bias adjustment for the BBD. If so, it’s a set and forget kind of thing.Not sure what the trimpot does, but you could use a six hole and wire a pot for the trimmer, may not be practical depending on function
Yeah wouldn't want that out frontThat’s almost definitely a bias adjustment for the BBD. If so, it’s a set and forget kind of thing.
They don't have any 2 footswitches enclosure at Tayda...Would that use a 5 knob enclosure from Tayda?
They don't have any 2 footswitches enclosure at Tayda...
This isn't the 2 footswitch version.
At least one part of the schematic is going to be quite familiar to you...Really curious to see the schematic.
Build docs?At least one part of the schematic is going to be quite familiar to you...
These will be available tomorrow.
BTW, I noticed there's a drilling service in Tayda which appeared recentlyStill unsure whether there's a predrilled enclosure for this from Tayda.