Hello,I'd been on a good building roll until I hit this problem. I get a full signal when bypassed but when engaged there is a very weak clean guitar signal and some background white noise that changes when the knobs are rotated. I used an AN307 for D2 but wasn't sure which side the cathode was on so I tried both directions but still no fuzz.I tried two different NE5532 chips from two different suppliers and I get the same readings. Any help will be appreciated
pin1 3.03
pin2 3.03
pin3 3.03
pin4 0
pin5 2.92
pin6 3.03
pin7 3.08
pin8 6.27
pin1 3.03
pin2 3.03
pin3 3.03
pin4 0
pin5 2.92
pin6 3.03
pin7 3.08
pin8 6.27
Attachments
Last edited: