Current Lover Wiring Question

[Erik S]

Boxing up this current lover and getting ready to wire it.

Have any of you built the 2024 version and wired the stomp switch without a daughter board?

Want to share a pic so I don’t have to use my brain?

The layout of the wiring connections changed a little from the version pictured in the build doc.

Also - I didn’t see an LED and CLR in the schematic, so I guess I’ll need to run one in-line to the LED?

 

[JohnnyCreepy]

Good guess? Dunno if snd and rtn are other way around. Easiest to check if led pwr out from board is 9v or 18v before choosing voltage dropping resistor.

Gnd wires are missing from my sketchy sketch.

 

[Erik S]

Thanks for the sketch @JohnnyCreepy !

That looks like a workable layout to me.